Perfect gents just what i needed

Great work, I think the carpentry are my favourite episodes. There’s no need for pink board under the stair. Neither storey is relying on it for escape and the stair is open to the room, so it’s not required from a regs point of view. No harm in doing so of course, but omitting it may mean you don’t need to add a bead trim on the underside of the stringer.

@mrabuilders6723 From everything I understand in researching the topic, using foil insulation can create issues. It will act as as a vapour barrier and will encourage condensation and rotting of the top deck. The VCL you have at the bottom has to be the one keeping the warm moist air within the room envelop, offering maximum control/minimizing the heating bill. Then any vapour that does go above it should be facilitated/encouraged to disperse out. The glue inside the OSB top deck is going against that concept, and so is the foil of the insulation (x2 since you have foil on both sides or 2 additional VCL). I'm not a builder, feel free to correct me if I'm wrong. I'm planning to use tissue faced PIR for my warm roof, and being a sloped roof, I'm just going to skip the entire top deck altogether. Interesting bit about the fixing, these little details are always very appreciated in videos. Thanks for sharing

I swear that cat miaows in a brummie accent.

Buying a house these days is not cheap and then some time later only to discover a fault like this one it must be gut wrenching.

Most kitchen designers haven’t got a clue? 😡

Absolutely

I wondered about the backfilling of the 'holey' floor. Why has Matthew not been subjected to a Disney voice, "hello"....???

My labourer as broke his hand at boxing I’m in the same boat on some apartments,

I've only heard ashlar referring to squared off or fine jointed sandstone masonry before.

Use pizza cutter sharpened. Get the catering 6inch ones and it cuts up to 120mm no problem. Do dust at all

Very good. Very entertaining...! Poor old 'Dickie'. I always think Slade music will get played when you have musical interludes. Dont know why, but hey....!

I'm interested to see a video where you break into the site at night to see how the build is now progressing.

Thanks guys for video , this is what i need to know , as soon as i see the square cut in insulation i knew what to do , still watched full video .

Without sounding too much like an arse,I can imagine there could be issues regarding the fitting of the dishwasher,re. the fixed aluminium trim/and the final dishwasher height,especially if it is a fully integrated model,I like your attention to detail re. the fitting..the problem with "kitchen designers",is that they invariably do not have any experience regarding the challenges etc,as a result of their designs..as you have found out,and I say,anyone who has fitted kitchens,unless the designer has had prior fitting experince..

We’re do you put transformer

How much like this cost

Hi. Are the top of the Rafters just screwed into the wall plate? I'd assumed I would have to do a Birds mouth at the top..? Also what fixings did you use for the wall plate? Thanks I'm currently building a wooden lean to at home.. Thanks.

After all that the risers look the same shade as the rest of the decking!

I was having a giggle at your expense when some bit of this incredibly techie job went a bit wobbly, and the phrase "6P" came to mind(Proper prior planning prevents p**s poor performance).. Not actually applicable in this case but it was the realisation that the standard opening hinges of those top upward opening cupboards were going to hit the ceiling!!! Another learning moment. That said what a great job.

Fantastic work ❤

Brilliant. 25 minutes! I'm a new-build developer. Doing this myself will really give me more control of time and profits.

Bonjour Big Nuts.... Do you you think those bosch holesaws are worth the money.. do they actually work without burning out on mdf? The white progressors are dear enough 😅 but crap in mdf and wear out quick in mfc.

As a DIY enthusiast with some big projects of my own to work on I love all Mr A Builders videos as they help me no end. I recently installed my own kitchen (first time) and I bought myself a Stabila digital level (told the wife I neeeeeded to have it). I found the digital part very useful when levelling the cabinets as it provides an audiable tone when perfectly level. it meant i could just adjust the feet and listen to the tone rather than checking the bubble after every twist. Every little helps. 👍

or dont take the job on

put it right

Was it me ..... that cat had a Brummie accent! 🐈‍⬛🤣

I like a man who glues his dowels 👍

Another great video Rich! Can I ask, in the video at the 27 min mark, you are set up in the utility room with your chopsaw. Where did you get the roller that looks like its adjustable like a scissor jack?

When cutting the end panels at point 24.13 it looked like you took a shallow pass first, then lowered the saw to full depth. Do you this to help prevent breakout on the face of the board ? Presumably this kitchen was supplied by a different company as I thought you guys only fitted kitchens from a company called Chase?

Those tall units are tough to assemble and position. Will you be adding a balustrade around the top of the stairs?

Rich, you never cease to amaze me with your skill, attention to detail, problem solving on the go and all round humour. I doubt very much there is anyone out there better than you. Bravo.

Do the base units each include a pullout step ladder so the homeowner can gain access to the Everest cupboards?

Hey Rich. Fantastic video and workmanship as always! It's all coming together now. I notced the blue lights in the fireplace behind the wood burner. Looking to do somthing similar. Do you know what kind they are? Thanks Peter

been there done that ! mwahahahahaha

Why did you fit the units before the the floor was Latexed, Feathered and boarded ? Thats not the correct way to do it! Your job would of been easier on a nice LEVEL floor obviously!! Maybe you were under pressure to get the kitchen done? It probably took longer doing it back to front! I look forward to your reply🤔🤔

The bush is a cotoneaster. Not sure which kind and cannot say why the one you showed has a bad odour.

Nice work as always. Wanna hear my radical concept? No wall mounted cupboards. I have an irrational hatred of them. They make a room feel oppressive and cramped and only serve as a place to store crap. I didn’t put any in when I replaced our old kitchen and the room feels open and spacious and allows room on the walls for a bit of wanky art and a narrow shelf of fancy tat my wife likes to display. Trust me you don’t need them. We can adequately store all our stuff in floor mounted cupboards, (family of four). More cupboards = more space you don’t need so you fill it with crap. Try it, I dare you.

Is it just me or is the audio very quiet this week?

The staircase looks great! I am planning to do something simular myself but will have the opening white instead of bare plaster. 😊 I noticed when the glass was being put in 😅

Fantastic video Rich excellent job

How long has this job taken ? 😂

Smashing video Rich. You’ve done a great job on the kitchen and the flooring looks fantastic. I’ve really enjoyed this series and the music. I’ve have learnt a lot from you guys. Take care guys till next week 😁👍

I think the safety rail at the staircase would be a priority , rather than the kitchen .

I think the flooring looks very good indeed. It's nice to see the latexing and overboarding done correctly.

Nice work as always, the only thing I'm not understanding is that cupboard in front of the underfloor heating manifold. So they've got a cupboard, that has a rear piece that is attached with Q Clips hiding the manifold. If any work needs doing on the manifold will it be: 1. Remove the top workpiece (single piece of quarts or whatever it is covering the cupboard and appliances) 2. Knock back panel towards front of cupboard to disconnect Q Clips 3. Lift back panel out Please tell me those deaths stairs the customer did from the old part of the house to the new house aren't staying?! 🤣

I wont say it would be my choice or plan, but wow, looks like a great use of what was wasted space, and now usable space, and a Customer, who wants to put their own bits in, is great, that media wall, looks the bloody fab!

Is it just my tv or is the sync between audio and vision is out?? Notice it on a few episodes now 🤔 Those lift up double doors probably shouldn't have been used on that job because you probably not get in the top cupboard, im speaking from experience here because ive fitted some beforehand and they were a right mare lol, customer wasn't happy 🤷‍♂️ love the channel guys 👏

Nice job again well done to the team what the name of the joiner how going to finish the job for you keep up the amazing work you are all doing 👏 👍