Triumph Speed Triple 2009 engine rebuild time lapse video

2009 Speed Triple. Engine rebuild time lapse video.
Had work done on the gearbox = engine out job.
setup a camera on various stages of the rebuild.
Input shaft gears got damaged some how (maybe a gear mesh crash after a false neutral?) also main bearings were replaced to eliminate some weird noises distracting me from the engine note.

[@gregorybester2674]

Love the music!

[@mmm4638]

Mine 17k miles engine stuck not seized stuck say at 12oclock either way you turn the motor it turms but hits somethinh and stops. Also doesnt stay in neutral. If you can point me to a direction that would be nice

[@reedwortman8355]

Hi there! Is there any way you could upload a video showing all the wire connections on the engine? I ran into a wiring problem on my speed triple and that would really help!!

[@Fabianweso.]

hi to get to the shifter forks do you have to take apart the top end?

[@jastheacenz]

Great job and very nice looking bike at the end, Cheers from New Zealand

[@slabbyrider8665]

You built it on the floor? 😳 No bench.?

[@RossRS]

Nice work! Did you have to fully remove the swing arm bolt or just loosen it?

[@ak5609]

Can I send you a description of my engine problem on a tiger 1050 and get your opinion?

[@NikitaChe76]

7:11

[@ibyhaych8221]

Hi, excellent stuff! I just finished doing the same recently there was a crack in the bottom half of the engine and the pistons were stuck so had to pull the engine apart and fix this.

[@realdragon13]

Hey Gavin, I'm about to do a gearbox repair and will be using your video as guidance for engine/gearbox removal and installation. That special socket you show at

[@jackarlanda2570]

tu n'aurais pas une vidéo explicative pour démonter et remonter la boite de vitesse par hasard ? moi aussi j'ai des bruits bizarres , une boite dure sauf à haut régime, je voudrais contrôler avant de voir si faut remplacer un truc mais la RTA est pas trop claire pour moi

[@joshvieira9976]

My triumph is not starting, it’s just cranking.

[@796andy2]

nice work !

[@davidselle1284]

Vidéo intéressante, mais attention le dernier disque d'embrayage est mal positionné, il ne doit pas être dans l'alignement des autres!

[@soares4694]

muito rápido dz pra ver nada