Smittybilt XRC corner video Installation

Check out our step by step guide to installing Smittybilt XRC Corner Guard Installation video by Morris 4x4 Center.Upgrade your Jeep with this step by step installation video.
www.jeep4x4center.com/smittybi...

[@vinbarone4138]

Great Video, Very Informative and the step by step makes it easy

[@omega77ish]

Great 👍 video! Helped a lot! Thanks 🤘🤘 you guys rock!

[@jeffvandermeulen5041]

tHANKS FOR SHARING THE VIDEOS BEATS THE HELL OUT OF THE BLACK AND WHITE INSTRUCTIONS THAT CAME IN THE BOXES..

[@jacoboleneack930]

You are not Jeff Vandermeulen

[@rickyweymers9209]

Yes it protects the body you just drilled full of holes and paintbrushed so that it can hold moisture between the panels and rot out instead of getting a dent

[@questioneverything3332]

The barricade brand corner guards are the same but cheaper. Remember you don't have to disconnect the wiring on the passenger rear light and remove the plastic inner fender wells held on by push pins so get extra.

[@six66string]

I’m getting these corner guards for Christmas from a friend and had a question about the optional fender. Is that the only fender that can be fitted on top of the guards? I was curious because I’m only getting the back guards and not the optional fender or matching front fenders so could I put the fender I have now on the guards? They are the stock Tj fenders btw. Any info would be greatly appreciated.

[@sijonda]

I keep thinking about all the crap that will get stuck behind those covers over the years.

[@garypiont6114]

Gee can one use vinegar and used steel wool to exasperate the iron oxide.

[@Bottle.fed_RT]

Will after market flares work? Like bushwaker flat fenders ?

[@rjet43]

So how do you get to the bolt next to the tail gate hinge? Its behind the evaporation box I believe.

[@moparlover1968rr]

I’m guessing it beats doing bodywork to get rid of rust, when you can grind it off, apply stop rust, then these protectors

[@careynotman5802]

How much of a lift is on this jeep? Thanks!

[@crossbonesjeep]

So no seal behind it? No caulk used to keep moisture or liquid from dripping behind the guard and the body of the Jeep?

[@jeffreyservay6224]

I was thinking the same thing. Depending where you live, those rear quarter panels will rust if exposed to high moisture and/or salt. I was thinking tig welding them to the quarter panel

[@4-WHEEL-DRIVE]

nice and sweet jeep tj but i hate body lift

[@McScribbleDude]

Hey Adam if memory serves me correct I had to drill a hole with a hole saw -1 inch and put a wrench in there to hold nut. Hope this helps.

[@xmccalla]

Alright Morris 4x4... Watched your video, got all charged up! Bought the same guards, got all the way through EXCEPT for 1 darn bolt. In your video, you don't show the passenger side install. :-( The bolt on the passenger side, very back, just LEFT of the tail light... Any recommendations on how to get to the backside of that hole? I mean, it's drilled, deburred and painted. But man, that's a doozie. Words of wisdom would be much appreciated!

[@Matt-kn9op]

That poor jeep

[@horaciogonzalez8160]

Hahahahaha if only it would be that straight forward or better yet ... the part being straight would be great. Just got mine and the are bowed to crap and not 2 holes match.. very disappointed

[@germaned.lealnino631]

Poor jeep